Product Details:
Minimum Order Quantity | 10 Bag |
Surface of Application | AAC BLOCK FIXING, Ceramic |
Grade Standard | Chemical Grade |
Brand | Chemax |
Features | Heat Resistant, Water Resistant, Vibration Resistant, Moisture Resistant, Impact Resistant |
Color | Grey |
Storage | Should Be Stored In Dry Place For Better Result |
Shelf Life | 12 Month |
Coverage Of Jointing Mortar | 150-160 running ft |
Block size | 600x200x150 mm |
Average Thickness | 3 mm for 40 kg bag |
Chemax Block Crete is made from a unique combination of cement, graded sand and selective additives. The unique chemical combinations enable this mortar to more compact, thinner and more versatile. At only 3 mm thick it is far through than the conventional mortar which is between 12-18 mm. It is pre mixed so it is easy to use and also ensures the compaction of interlocking bricks making the bonds tougher and more durable.
Surface Preparation:
Surface of masonry units should be slightly wet prior to application if Chemax BlockCrete. The masonry units should be clean with no Loose particles or dust for better bonding. Surface must be structurally sound. Surface defects such as cracks, holes of voids should be repaired prior to application.
Mixing:
It is very important that Chemax Block Crete is mixed with water thoroughly before use. It is advisable to use a Mechanical stirrer for uniform mixing to save time, labor and maximum workability effectiveness. Used a clean vessel / bucket and some water in the empty vessel to ensure no power gets stuck on the bottom of the vessel and put required quantity of Chemax BlockCrete. Mixing ratio depending on the thickness of the product to be applied. Add approximately mix 25-30% of the clean water and 70% of powder and mix. Water is added in stages to get a smooth uniform workable mix. Allow time for initial mixing.
Method Of Application:
Lay out the wall where Chemax Block Crete is to be used and mark opening like door, windows. Apply a thin uniform layer of Chemax Block Crete 3 - 4 mm thick on the clean and level surface of masonry unit using proper trowel. Place the next course of masonry units on the evently laid jointing mortar bed in proper line and level. Each masonry unit shall be properly bedded and set in position by gently pressing with the handle of trowel
After placing the first units apply Chemax Block Crete of same thickness on both the side of the unit.
Additional Information: